180/4FM
|
| Specification: |
|
Head sequence:-
|
First Bottom
Fence Side
Near Side
Top
|
|
Motor powers:-
|
1 x 7.5 kW (10hp) to horizontal heads
1 x 7.5 kW (10hp) to vertical heads
|
| |
| Capacities: |
| Finished side capacity |
180 x 120mm |
| Minimum finished width |
23mm |
| Minimum finished thickness |
6mm |
| Spindle diameter |
40mm |
| Minimum length through-feed |
430mm |
| |
| Cutting Circles: |
| Maximum cutting circle |
137mm diameter |
| Minimum cutting circle |
100mm diameter |
| Maximum cut on first bottom and fence side head |
10mm |
| Edge reference system to first bottom head, for
perfect edge straightening |
| |
| Feed System: |
| Shaft/chain drive to feed-works |
| Spring loading to feed rollers |
| Feed roll diameter |
120mm |
| |
| Electrical: |
| Feed motor 0.7 / 1.1 kW |
| 400v/3ph/50hz |
| Motor start and stop buttons |
| Control panel master stop |
| Lockable isolating switch |
| No volt and overload protection |
| |
| Feed selections: |
| 1.7 metre long in-feed straightening table and fence |
| Feed speeds |
6 & 12m/min |
| Spindle speed |
6000 rpm |
| |
| Cutter equipment: |
| Set of 3 knife cutter equipment comprising of: |
| Edge reference disc 140 x 10mm |
| Two 190mm x 120mm diameter three knife planing cutterblocks
each with three 3mm HSS knives |
| Two 130mm x 120mm diameter three knife planing cutterblocks
each with three 3mm HSS knives |
| |
| Included with the machine: |
| Lift up front safety cover electrically interlocked
with timed control |
| Mechanical digital read-outs for width and thickness
measuring 0.1mm |
| Idle side roller pressures opposite fence side head,
moving with near side head |
| Dust hoods (120 & 150mm outlet diameter) |
| Instruction and spare parts manual |
| |
| Includes: Internal light, bed lubrication, 300mm
infeed table extension |
| |
to Planer Moulders
